Pengaruh Variasi Putaran Mesin Terhadap Unjuk Kerja Mesin Pencacah Plastik

  • Ahmad Rito Nuardi Universitas PGRI Banyuwangi
  • Ikhwanul Qiram Universitas PGRI Banyuwangi
  • Anas Mukhtar Universitas PGRI Banyuwangi
DOI: https://doi.org/10.36526/v-mac.v4i1.640

Abstract

This research is using plastic material with large size into the place of the counting, the material is torn, pulled, crushed, and crushed by two cylinders composed of a knife or spinning the crusher in the opposite direction and material becomes Soft. By adjusting the engine round variation of 200, 300 and 400 rpm and variations of plastic material in the form of rice containers are made of intact and perforated. Thus obtained results that resemble plastic beans for recycled materials. Results of research data on the influence of the variation of the engine rounds on the performance of plastic counting machine, with the change in the results of the difference in the RPM is influenced by the smaller the number (6.68) then the size of the shape at the speed RPM 200. Instead in a large rpm, the weight change of the results of the number (12.6) of the size of the shape at the speed of 400 rpm in whole plastic material.

Published
2019-04-24
How to Cite
NuardiA. R., QiramI., & MukhtarA. (2019). Pengaruh Variasi Putaran Mesin Terhadap Unjuk Kerja Mesin Pencacah Plastik. V-MAC (Virtual of Mechanical Engineering Article), 4(1), 10-12. https://doi.org/10.36526/v-mac.v4i1.640
Issue
Vol. 4 No. 1 (2019)
Section
Artikel

uthors who publish with this journal agree to the following terms:

1. Copyright on any article is retained by the author(s).

2. The author grants the journal, the right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgment of the work’s authorship and initial publication in this journal.

3. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal’s published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in this journal.

4. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work.

5. The article and any associated published material is distributed under the Commons Attribution 4.0 International License.